Quick answer
Ask for a line-item EA3DiP1 quote, not one blended poster price. Separate the chosen P1.25, P1.56 or P1.86 pixel pitch, the control configuration that provides independent signal input for all four screens, content preparation for the naked-eye 3D effect, the caster-wheel base, and remote content management. Then request written inclusions, exclusions and pre-production confirmations. (1)
Start with the pixel pitch line, not a blended poster price
The EA3DiP1 is a four-sided indoor 3D LED poster display for commercial deployments, with a 680 × 680 × 1,920 mm cabinet. It is offered in P1.25, P1.56 and P1.86 pixel pitch. Because those are distinct configurations, a quotation that gives only one poster price leaves the buyer unable to see which pitch is being supplied. Ask for the exact pitch to appear as its own line, tied to the exact cabinet model and the intended indoor site. (1)
The source states that every EA3DiP1 configuration provides 600 cd/m² brightness, 10,000:1 contrast, 16-bit grayscale and a 3,840 Hz refresh rate. That does not make the pitch choice interchangeable for every project. The buyer should still require the quotation to identify which of the three pitches is being offered and to put related display items on the same line. If the project has a specific close-range viewing plan, ask the supplier to confirm the pitch against that plan rather than assuming the finest or coarsest option is the right one. (1)
The four-sided form factor also needs a cabinet-related line. The source describes flexible LED modules that wrap around all four vertical corners to reduce visible gaps between display faces, plus a 170° viewing angle. If corner appearance matters to the project, ask how the quoted modules and cabinet handling are specified for the EA3DiP1. This is a request for written scope, not a claim that any particular module set is automatically included. (1)
Separate the four-face signal and control configuration
EA3DiP1 supports independent signal input for all four screens, with switching between single-screen and four-screen playback modes. The source also says all four faces can show synchronized content, or the configured control system can send independent signals to each screen. A quotation should therefore separate the display hardware from the control configuration that delivers those modes. Ask for the line to state whether the quoted system is set up for one content stream across four faces, independent streams per face, or switching between both. (1)
The control scope does not end with input mode. The source states that operators can remotely monitor the display, schedule power-on and power-off times, and manage content wirelessly from a mobile device, subject to the configured control system. Put those capabilities in the quotation as scope items, and ask what “subject to the configured control system” means for the exact control package offered. A quote that lists only the poster cabinet may not show whether the intended operating method is included. (1)
A practical quotation request is to name the source devices and mode changes the buyer expects. If the four faces will normally show one synchronized campaign, ask the quote to reflect that. If different faces will carry different promotions or sponsored content, ask the quote to reflect independent signal input for all four screens. Avoid letting the control configuration be described only as remote control. Make the quote state the playback modes, monitoring and scheduling included for the EA3DiP1. (1)
EA3DiP1 quotation decisions and evidence to request
| Decision | What to itemize in the EA3DiP1 quote | Evidence to request | Sources |
|---|---|---|---|
| Pixel pitch | Exact P1.25, P1.56 or P1.86 configuration and the cabinet line it applies to | Written pitch, cabinet model and the site conditions used to select it | 1 |
| Four-face signal control | Control configuration for synchronized faces, independent signals per face, or switching between single-screen and four-screen playback | Written statement of playback modes, source arrangement and configured control system | 1 |
| Naked-eye 3D content | Content preparation required for the correct perspective in the installation’s viewing zones | Written description of content files, preparation service and playback setup included or excluded | 1 |
| Caster base | Caster-wheel base and indoor mobility arrangement for the 125 kg unit | Confirmation of base scope, floor loading, route and venue conditions | 1 |
| Remote content management | Remote monitoring, power scheduling and wireless mobile content management subject to the configured control system | Written statement of which remote functions and control system are included | 1 |
| Pre-production conditions | Viewing distance, content perspective, floor loading, power, signal routing and maintenance access | Written confirmation or buyer-supplied record before production | 1 |
Make naked-eye 3D content preparation a visible line
The EA3DiP1 creates a naked-eye 3D LED display effect without glasses when content is prepared with the correct perspective for the installation’s viewing zones. That makes content preparation a quotation decision, not a decorative extra. Ask whether the quote includes content preparation, who is responsible for adapting content to the four-sided cabinet, and what viewing zones the content is prepared for. (1)
The source ties the effect to correctly prepared perspective content and to the continuous corners and 170° viewing angle. A useful quotation request is therefore to separate the display and control scope from the content-preparation scope. Ask for a written description of what will be supplied: source files, preparation service, playback setup, or a combination. Buyers should avoid treating a sample video as proof that their own content will produce the same result unless the scope states how that result is prepared. (1)
Before production, the source advises confirming viewing distance, content perspective, floor loading, power, signal routing and maintenance access. For a quotation, those confirmations should be recorded alongside the line items because they can change what must be supplied. If the project wants a naked-eye 3D campaign in a mall atrium, retail entrance, exhibition stand or theater lobby, ask the supplier to state how the quoted configuration and content preparation match that specific viewing situation. This is a supplier request to put in writing. (1)
Quote the caster base and the indoor deployment conditions
The EA3DiP1 base includes quiet universal caster wheels, and the source describes repositioning a 125 kg unit between indoor locations. A quotation should not leave the base ambiguous. Ask for the caster-wheel base to be named in the quote and for written confirmation of the conditions under which the unit can be moved. Because the display is a 125 kg unit, floor loading and route planning should be confirmed with the venue before production. (1)
The source presents EA3DiP1 as an indoor cabinet designed for close-range commercial installations rather than outdoor billboard deployment. It also lists front-service access, where modules and key components are accessible from the front without rear service clearance. For a quote, ask whether the proposed position needs front service only, and confirm that any wall, fixture or pedestrian route nearby still allows the required maintenance access. These are project conditions to record in the quotation scope. (1)
Mobility also affects the power and signal plan. A display that can be repositioned indoors still needs an agreed power and signal route at each location; the source advises confirming floor loading, power, signal routing and maintenance access before production. Ask the supplier to state which installation checks are included in the quote and which remain the buyer’s responsibility. This keeps the caster-base line from being mistaken for a complete installation scope. (1)
Remote content management and what the quote should hand over
EA3DiP1 supports remote content management: operators can remotely monitor the display, schedule power-on and power-off times, and manage content wirelessly from a mobile device, subject to the configured control system. The quotation should identify the configured control system and list these functions as included or excluded. Ask what device, account or network arrangement is required for the remote management being offered. This is a request for written scope; it does not assume a particular management platform is included. (1)
Remote management is distinct from independent signal input. EA3DiP1 supports independent signal input for all four screens, with switching between single-screen and four-screen playback modes. If daily operation depends on changing content per face and scheduling power times, the quote should show both the control configuration and the remote management line. Otherwise, a low headline price may leave the buyer to source or configure part of the operating setup separately. (1)
At handover, ask for a written record of the control configuration, the remote functions enabled, and any content preparation files that were supplied. The source describes remote monitoring, schedule power-on and power-off and wireless mobile content management subject to the configured control system. Because that phrase makes the control system the condition, the buyer should ask the supplier to state exactly which system is being quoted and what it enables for the EA3DiP1. (1)
EA3DiP1 deployment scenarios and what to confirm in the quote
| Scenario | What to confirm | Sources |
|---|---|---|
| One synchronized campaign across four faces | A control line that states synchronized four-face playback and any remote scheduling included | 1 |
| Different content or sponsors per face | Independent signal input for all four screens and switching between single-screen and four-screen modes | 1 |
| Naked-eye 3D campaign | Who prepares perspective content for the viewing zones and how that preparation is quoted | 1 |
| Frequent indoor repositioning | Caster-wheel base, 125 kg unit handling, floor loading, route, power and signal at each location | 1 |
| Remote-operated daily schedule | Configured control system for remote monitoring, power scheduling and wireless mobile content management | 1 |
| Close-to-wall or pedestrian route | Front-service access and whether nearby walls, fixtures or routes still allow maintenance access | 1 |
Buyer checklist
- Request separate quotation lines for pixel pitch, four-face signal control, naked-eye 3D content preparation, caster base and remote content management. (1)
- Require the exact EA3DiP1 pitch and cabinet scope to be named against the 680 × 680 × 1,920 mm cabinet being quoted. (1)
- Ask how independent signal input for all four screens and single-screen or four-screen switching are configured. (1)
- Ask what perspective content preparation is included for the installation’s viewing zones and who provides it. (1)
- Confirm the caster-wheel base, 125 kg unit handling, floor loading, power, signal routing and maintenance access. (1)
- Put the remote monitoring, power scheduling and wireless mobile content management scope in writing, subject to the configured control system. (1)
Frequently asked questions
Is an EA3DiP1 quote the same for P1.25, P1.56 and P1.86?
EA3DiP1 is offered in P1.25, P1.56 and P1.86 pixel pitch, and the source states every configuration provides 600 cd/m² brightness, 10,000:1 contrast, 16-bit grayscale and a 3,840 Hz refresh rate. Ask the quotation to identify the exact pitch and to relate that line to the project’s viewing plan rather than comparing only a total. (1)
Does independent signal input for all four EA3DiP1 screens come automatically?
The source states that EA3DiP1 supports independent signal input for all four screens, with switching between single-screen and four-screen playback modes, and that all four faces can show synchronized content or the configured control system can send independent signals to each screen. Ask the quote to state the configured control system and the playback modes included. (1)
Is the naked-eye 3D effect part of the poster hardware price?
The source states that the naked-eye 3D effect without glasses is created when content is prepared with the correct perspective for the installation’s viewing zones. Quotation scope should therefore separate the display and control hardware from any content-preparation service, source files or playback setup being supplied. (1)
What should be confirmed about the EA3DiP1 caster base and 125 kg unit?
The source states that the base includes quiet universal caster wheels and describes repositioning the 125 kg unit between indoor locations. Ask the quote to name the caster-wheel base and confirm floor loading, route, power, signal and maintenance access for each intended indoor position before production. (1)
Can remote content management be itemized separately from the signal configuration?
Yes as a quotation-scope request. The source states that operators can remotely monitor the display, schedule power-on and power-off times, and manage content wirelessly from a mobile device, subject to the configured control system. Ask the quote to list those functions separately from independent signal input and playback-mode switching. (1)
What pre-production conditions should be recorded with an EA3DiP1 quotation?
The source advises confirming viewing distance, content perspective, floor loading, power, signal routing and maintenance access before production. Put those confirmations beside the quotation lines so the buyer can see whether the proposed configuration fits the room and the intended four-sided 3D content. (1)
Further reading
- Indoor LED screen price: scope the wall before the quote
- How to specify an LED display factory acceptance test
- Signal redundancy evidence for an LED wall
- Calibration files to request at LED wall handover
- Operator training scope for an LED display purchase
For an EagerLED quotation, share your project requirements through EagerLED’s official website.
CHECK THE DETAILS
Sources & references
Source pages can change. Access dates record when they were consulted for this guide.
- 3D LED Poster Display | EA3DiP1 Four-Sided 360° Accessed 21 September 2026
Put these details into your project brief.
Tell EagerLED the application, destination and screen dimensions you have in mind.
Request a project quote